Although this entry focuses on the experience with the the KIRK 6000 Server, it also applies to the KIRK 300 server, although the sections within the configuration space may be a bit different. Look for the key words and entries specified below, when configuring the 300, and it should work.

Additionally, this page focuses solely on basic KIRK phone/voice operability with SIPX, and does not cover the extended features offered by the KIRK 6000.

Fields not mentioned below should be left in their default state, unless you have specific requirements.

Setup of KIRK servers

Configuration section

General subsection

• Use static address (not absolutely required, but recommended for ease of management). Define IP Address, Netmask, and Gateway.
• DNS. Domain should be your SIPX domain, and set the Primary Server to your SIPX server (if you are serving DNS from the SIPX server) or to the appropriate server with the correct SRV records.
• NTP. IP or FQDN should be set to an appropriate NTP server. I recommend the SIPX server. Time Zone should be set as appropriate.
• UPnP. Enabled, and Broadcast announcements checked.

Wireless subsection

• Under the DECT header, place a checkmark in the following: 'Subscription allowed', 'Authenticate calls', 'Send date and time', 'Allow new media resources', 'Allow new base stations'.

SIP subsection

• Local port: 5060
• Transport: UDP
• DNS method: DNS SRV
• Default domain: YOUR SIPX DOMAIN HERE
• Registration expire: 3600
• DTMF signalling, send as RTP: checked
• Message waiting indication: Enable indication checked, enable subscription checked, expire in 3600.
• Media Codec priority: Set to G726-32/8000
• Play on-hold tone: checked
• Display status messages: checked
• Call waiting: checked

Still working on this...