Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

Although this entry focuses on the experience with the the KIRK 6000 Server, it also applies to the KIRK 300 server, although the sections within the configuration space may be a bit different. Look for the key words and entries specified below, when configuring the 300, and it should work.

Additionally, this page focuses solely on KIRK phone/voice operability with SIPX, and does not cover the extended features offered by the KIRK 6000.

Setup of KIRK servers

Configuration section > General configuration sub-section

  • Use static address (not absolutely required, but recommended for ease of management). Define IP Address, Netmask, and Gateway.
  • DNS. Domain should be your SIPX domain, and set the Primary Server to your SIPX server (if you are serving DNS from the SIPX server) or to the appropriate server with the correct SRV records.
  • NTP. IP or FQDN should be set to an appropriate NTP server. I recommend the SIPX server. Time Zone should be set as appropriate.
  • UPnP. Enabled, and Broadcast announcements checked.
    *
  • No labels