...
Log into Quadro E1/T1 Gateway and Run System Configuration Wizard.
Host Name - – Give this device a unique Hostname
Domain Name - – enter domain name used on sipXecs Server
IP Address - – Provide unique IP address on same subnet as sipXecs Server
Subnet Mask - – Provide Subnet Mask appropriate for this subnet
<Click Next>
It is recommended that the Quadro is not used for the DHCP.
Untick the DHCP Option
<Click Next>
Locale - – Select Country where Quadro is being installed
Timezone - – Select correct timezone.
<Click Next>
View Summary Screen
<Click Finish>
Run Internet Configuration Wizard
Uplink Configuration - Select Ethernet. Set speed to appropriate setting.
<Click Next>
WAN IP Configuration - Select IP method - – DHCP or Manual. Enter WAN IP if Manual
<Click Next>
PPTP Configuration Settings
<Click Next>
Wan Interface Configuration
<Click Next>
DNS Settings
Enter DNS address for the Network
<Click Next>
Review Summary Page
<Finish>
Configure E1/T1 Settings
Interface Type - If Quadro is connected to a PBX, select Network for your interface type. Otherwise, select User
Select Signaling Type -– CAS or CSS CSS=PRI
If you select CCS signaling type, you will be taken to a new screen - – Signaling Type CCS
Enter PRI configuration information provided by your PRI service provider.
Under Route Incoming Call - – Select Route with Inbound Destination Number
...