General Phone Information

Cisco Manual

NOTE: If you attempt to upgrade firmware AFTER entering phone into sipXconfig interface run this command

then follow these instructions.

Setting up with sipXecs

Beyond adding an entry in the phone list for your Cisco phone and assigning a user to that phone, there are a few more steps you meed to make to this phone work.

...

1. Power the phone up
2. Press the Menu button
3. Use the Navigation button to select Settings, and then press the Select softkey
4. Use the Navigation button to select Network Configuration or SIP Configuration, and then press the Select softkey
5. Make a note of a phone's MAC address for a later configuration of this device in sipXecs
6. From the Network Configuration menu or the SIP Configuration menu, press **#
7. If your phone displays 'Enter Admin Password', enter your password and then press the Enter softkey
8. Set 'Alternate TFTP' to 'Yes'
9. Select 'TFTP Server', press 'Edit'
10. Set the IP address of TFTP Server to an IP Address of sipXecs, press 'Validate'
11. Press 'Save'
12. The phone restarts; the phone should get a new configuration from sipXecs's TFTP server

Changing the logo

To change the Cisco logo on your phone

...