Nortel Secure Router 2330
The Nortel Secure Router 2330 provides IPv4/IPv6 routing, survivable SIP-PSTN gateway, WAN connectivity and security services in a cost-effective modular platform.
It supports a variety of voice interfaces including T1/E1, BRI, FXS, FXO, DID and CAMA.
For more information see Nortel Web site
Nortel SR2330 SIP-PSTN gateway configuration for sipX
Please refer to Nortel SR2330 User Guide on detailed information on how to configure SR2330 SIP-PSTN Gateway feature. The examples below are intended to provide guidance regarding configuration of SR2330 for use with sipX server in specific application. The SR2330 configuration for each installation should match the network connectivity and requirements for that installation.
Configuring connectivity to sipX server
Configure connectivity to sipX server. Assuming FE 0/1 port.
| Panel |
|---|
interface ethernet 0/1 |
Configuring SIP server and registrar
Assign SIP domain (must match sipX configuration, eg. test.com).
| Panel |
|---|
sip ua |
Configuring SIP listen IP address and port
Configure SIP listen or "bind" IP address and port. Assuming FE 0/1 port connected to sipX server.
| Panel |
|---|
voice service voip |
Configuring a FXS port to connect an analog phone
Configure a FXS port, 2/1, to connect an analog phone with extension 1000. The SIP password 1234
(need to be same password as configured in sipX for phone number 1000)
...
| Panel |
|---|
destination-pattern 1000 |
Configuring a T1 port to connect to a PSTN switch
Configure a T1 PRI port, 4/1, to connect to PSTN switch. All calls with prefix 408 are routed
to this link. To receive and send calls from the sipX server to SR2330 PSTN trunks, one must
add SR2330 as a gateway to the sipX using sipX configuration server web user interface. A dial
plan also need to be added to sipx server to route the calls to SR2330 SIP-PSTN gateway trunks.
...